433Mhz RF Wireless Remote Control Switch AC 110V 120V 240V 220V 30A 4CH Relay For Garage Door Light Lamp Door Access System

Receiver

Working Voltage : AC 85V~256V
Input vlotage : 1~220V
Output vlotage : 1~220V
Quiescent Current : <5MA
Max current : 10 A
Max load : 2200W
RF frequency : 433MHz
Working temperature : -30~+80
Receiving Sensitivity : >97dbm
Amount of storage remote controls : 25 pieces
Support encoding : 1527 Leaning code
RF Operating mode : ASK superheterodyne wireless reception
Receiving range : Open space is more than 30 meters
Remote operating mode : Momentary Mode /Toggle Mode /Latched Mode
Output Terminal : NO / COM / NC

1.KC1 Normal Closed of relay (NC)
2.KC1 Common of relay (COM)
3.KC1 Normal Open of relay (NO)
4.KC3 Normal Closed of relay (NC)
5.KC3 Common of relay (COM)
6.KC3 Normal Open of relay (NO)
7.KC2 Normal Closed of relay (NC)
8.KC2 Common of relay (COM)
9.KC2 Normal Open of relay (NO)
10.KC4 Normal Closed of relay (NC)
11.KC4 Common of relay (COM)
12.KC4 Normal Open of relay (NO)
(When the relay is energized, NO and COM connected).

Remote Control

RF frequency : 433MHz
Support encoding : 1527 Leaning code
Transmitting range : up to 100 m (theoretical distance)
Battery : 12V 23A (Battery not included)

About Working Mode:

1. Momentary/Joggle:Press and hold->On; Release->Off
Keep pressing one button, the corresponding channel is working /on; Release your finger is stop/OFF. (4 channel switch(receiver) need 4 button remote control (transmitter )

2. Toggle/Self-Lock:Press->On; Press again->Off
Press one button for one time, the corresponding channel is working/on; Press the same button again to stop/OFF. (4 channel switch(receiver) need 4 button remote control (transmitter).

3. Latched/Inter-Lock:Press->on; Press other button->Off
Press one button for one time, the corresponding channel is working/on; Press another button is stop/OFF(At the same time, another corresponding channel works). (4 channel switch( receiver) need 4 buttons remote control (transmitter).

The Setting of Working Mode:

1.Momentary Mode:
Pressing the learning key button on the receiver board once (LED Indicator on receiver board will signaling simultaneously), then press any of the remote button, signaling three times by remote's LED indicator means setting Momentary Mode successfully.

2. Toggle Mode:
Pressing two times the learning key button on the receiver board twice(LED Indicator on receiver board will signaling simultaneously),then press any of the remote button , signaling three times by remote's LED means setting Toggle Mode successfully.

3.Latched Mode:
Pressing the learning key button on the receiver board three times (LED Indicator on receiver board will signaling simultaneously), then press first remote button, follow on second remote button, signaling three times by remote's LED indicator means setting Latching Mode successfully (first button stands for on, second button stands for off ).

This receiver contain 4 relays, and there are 3 terminals(normally open, common, normally closed) for each relay.This 4 relays are independent, so that you can remote control each of them independently by pressing the remote button. Each receiver can store about 25 transmitters. And One transmitter can control multiple receivers( the transmitter need to match with receiver ).For example you can use two relays to control garege door/ motor and the other two to control Lights.