T100 Auto Ignition System Detector For 12V 24V Ignition Systems,Detect the Ignition Signal And the Spark Voltage Engine Eetector

Description

T100Auto ignition system detector

Product function
:

1. Detect the ignition signal, and the flashing frequency of the indicator is consistent with the spark frequency.

2. Detect the spark voltage, the spark voltage displayed on the screen is the reference value, by comparing the spark voltage of each cylinder the cylinders with abnormal work can be found.

3. Analyze the performance and fault location of ignition system.

4. Suitable for four-stroke engine independent ignitionsystem (COP).

5. Suitable for 12V and 24V ignition system test.

6. Spark voltage display range 0-50KV

Specifications:
Component: Plastic
Color:Black
Model: T100
Power supply voltage: 24V
Working temperature: +20℃~+65℃

Analysis of Automotive Ignition System Malfunctions:

The ignition voltage of a certain cylinder is significantly lower than that of other cylinders, which may be due to:

1. Ignition coil insulation leakage, inter turn short circuit, ignition circuit failure, etc.:

2. Spark plug insulation leakage, small discharge gap, carbon or oil accumulation, etc

3. Low cylinder pressure:

4. Ignition timing error:

5. Mismatch of ignition coil or spark plug

The ignition voltage of a certain cylinder is significantly higher than that of other cylinders, which may be due to:

1. The gap between the spark plug electrodes is too large;

2. Poor contact between ignition coil and spark plug:

3. Mismatch of ignition coil or spark plug

Instructions for using T100 detection treasure

1. Start the engine, turn on the instrument power switch, and place the probe as close as possible to the top of the ignition coil;

2. Adjust the ignition signal knob so that the ignition signal indicator light flashes just right, and the probe moves slightly to turn off the indicator light;

3. Adjust the ignition voltage knob to ensure that the displayed value of the ignition voltage is between 10-30KV as much as possible:

4. Detect all cylinders separately, and then compare the values of the ignition jump voltage of all cylinders. Under normal operating conditions, for the same engine, using the same type of ignition coil produced by the same manufacturer, the ignition jump voltage should be the same or very close

5. If there is a significant difference in the ignition voltage value between a certain cylinder and several other cylinders, it indicates that there is a fault in this cylinder