Dental Orthodontic Adhesive Light-cure Kit Etchant Acid Gel Light-Cure Paste Light-cure Primer For Bonding Brackets Braces

Description

[Application]: This is for orthodontic bonding on all kinds of orthodontic brackets.

[Instructions]:

1. Tooth preparation: clean tooth enamel surface, remove the tooth surface dirt, rinse it with water; Isolate the teeth, with no oil and no moisture gun to dry the tooth surface.

2. Acid etching tooth surface: the etching agent coated on the tooth surface, about 50 to 60 seconds, rinse thoroughly with water, dry. Note: After etching the tooth surface was chalky.If there is no chalky appearance, prolong the acid etching time.

3.Primmer: with a small brush to brush a thin layer of liquid on the tooth surface, and then use a small brush to brush a thin layer at the bottom of the bracket (wet).

4.Adhesive: with a mixing bar to take a small amount of paste applied to the bracket surface.And immediately after applying the paste, the bracket will be bonded to the tooth surface.Pendulum bracket position, micro-pressure 5-10 seconds to prevent the bracket from sliding; and remove the excess liquid and paste.

5. Light curing: for metal brackets, on both sides with light curing machine for 10 seconds.The ceramic brackets illuminate the front of the brackets for 10 seconds. After the light can be orthodontic operation (light curing machine recommended LED type).

[Cautions]:

1. Tooth surface coated with primer, it can be illuminated for 2-3 seconds to increase the consistency and prevent the positioning of the bracket after the move.

2. The product is sensitive to light, the product is not used up, to avoid light.

3. Bonding Orthodontic bracket to be a regular manufacturer of qualified bracket, required by the professional doctor to complete the operation.